You might wonder how to do this? Well, there is nothing difficult about it. Dual flush toilet is the answer that you were looking for in order to lessen your water use. It should be added that there are dual flush toilet systems, where one lever flushes a full tank and one lever flushes half a tank. Needless to say that they’re unique, and, actually, they even add a certain amount of style to your bathroom.
The other great news for you to discover is that you will not necessarily have to replace your entire toilet. The truth is that you can even do it by yourself even if you are not a plumber. So, in order to renovate your toilet and make it more eco-friendly you should just buy a dual flush toilet retrofit kit. You need also to keep in mind that these kits are rather cheap and almost certainly you will not have problems while installing one.
So, in the case you decide to install this kit by your own, read carefully the next instructions that will definitely aid you very much.
The First Step – you should turn off the water supply to the toilet and drain tank and then utilize a sponge to remove the extra remaining water from the tank.
The Second Step – you should disconnect the tank’s inlet fitting from the water supply and then unscrew the two bolts that are there to hold the tank down to the toilet.
The Third Step – you should separate the flush handle from the tank and then put the tank down on a wipe. Then, using a channel-locking plier, remove the large flush valve holding nut.
The Fourth step – you should install the dual flush toilet kit valve – the tapered rubber gasket goes on the inside of the tank to prevent leakage. Remember that you should tighten large nut until secure.
The Fifth Step – you should install the two rubber gasket tie-down bolts and their lock nuts to the bottom of the tank. After that you should carefully bolt the tank down to the toilet using the second set of rubber gaskets and nuts. It is also useful for you to remember that at this stage it is recommended to apply totally new tank tie down bolts that can be simply bought at any hardware store at economical price.
The Sixth Step – you should assemble the new arms as per required length between the handles and the new flush valve. In the case there will be such a necessity, you can cut them with a hacksaw.
The Seventh Step – you should insert the small and large handles into the handle-hole in the tank (insert spacer if needed). Then you should hook long arm into overflow tube, and short arm into release pole. Slide short and long arms into place on the handles and utilize clip in order to make safe and then connect the refill tube from the fill valve to the nipple on the long arm.
The Eighth Step – you should release water supply to the tank. Be very cautious and fill slowly in order to trial for leaks. As a matter of fact you may want to label the large and small handles as “full” and “half”, but that is individual liking.
In the case you will stick to this simple instruction you will have no problems with the installation.
Read dual flush toilet reviews and cistern toilet info.
Check out useful information about internet marketing MLM – make sure to go through this webpage. The time has come when concise information is really within one click, use this opportunity.
You must log in to post a comment.