Those who have them they know it better that maintaining swimming pools is a tough task. People do not have any knowledge on cleaning the pools. Regular cleaning of pools is very important otherwise the water gets stagnated and becomes contaminated with debris, algae, and even germs.
Your swimming pool is recommended to be cleaned every fortnight. The filter used to clean the pool should also be maintained and replaced. To make sure your swimming pool stays clean specified types of filters are used.
There are various types of filters available for your swimming pool. They are Sand ” the bulletproof filter, Cartridge ” the economic low maintenance filter, and Diatomaceous Earth – the water polisher.
Sand filter is the most commonly and widely used filter. But one has to change the sand in the filter to make the filter more efficient. Otherwise, the dirt will penetrate so deep that normal backwashing doesn’t clean it completely because of the sand wearing out.
Removing the old sand is the first step towards changing your sand. Disconnect the plumbing attached to the valve of the filter. Start digging out the sand once you have opened the filter.
Digging out the sand has to be done by a small plastic cup rather than a shovel. While digging the sand out, care should be taken that you do not break the laterals of your underdrain. They are very fragile and are easily broken.
After removing the sand, examining the laterals is the next step. You can remove them easily by unscrewing it. For any damage or breakage, check it thoroughly and if there is any damage, then replace it duly. A mixture of dilute acid and water should be used to rinse it to remove all dirt in it.
The tank should be rinsed thoroughly after replacing the laterals. keep on pouring water till the tank is half full. After that, start putting in the sand. After you have added the proper amount of sand, reassemble the filter tank and/or multiple port valve. Always call the plumber for your assistance in case you face any problem during this process.
